G7 → Am: the chord change, slowly

G7 to Am is a intermediate chord change. You'll move every finger, but the shapes are close enough to learn in a single sitting.

The anchor finger

There's no anchor finger and the shapes are far apart on the neck. The trick is to lift all fingers simultaneously, see the next shape in your mind, and place all fingers as one motion. Slowness here is your friend; speed comes from accuracy, not haste.

Step-by-step: G7 to Am

1. Form G7 cleanly — fingers on tips, thumb behind the neck. Strum once and check that every intended string rings out.
2. Without strumming, freeze the chord. Look at the next shape — Am — in your mind. Picture which finger goes where before any finger moves.
3. Lift the fingers that need to move. Lift just enough to slide; don't fly off the fretboard.
4. Place the new fingers as a single motion. The goal is to land on Am in the same instant, not finger-by-finger.
5. Strum once. Listen. Adjust the finger that buzzed or muted. Repeat the change.

The 4-2-1 drill

This is the standard drill for any new chord change, named for the strumming counts: four strums on chord A, two strums on chord B, one strum each, alternating. It conditions your hand to associate the change with strumming time, not standalone time.

1. Round 1 — slow. 60 BPM. Strum G7 four times, switch to Am, strum four times, switch back. Don't speed up; the change is what matters.
2. Round 2 — halve the count. Same tempo. Two strums on each. Five minutes.
3. Round 3 — one strum each. Now you're changing every beat. If it falls apart, drop back to two strums for a minute and try again.
4. Round 4 — speed up. Move from 60 to 80 BPM, but only if round 3 was clean. Clean and slow beats fast and sloppy every time.

Common mistakes on this change

Three things go wrong here for almost every learner. First, the strumming hand pauses while the fretting hand is mid-change — this is the most common reason a beginner can't keep time through chord changes. The strum has to keep going; even if your fretting hand isn't ready, your strumming hand should still hit the strings. The unintended muted strum sounds bad in the moment but trains the right rhythmic habit.

Second, the fingers come down one at a time on the destination chord. Once you're past the first week of learning a change, switch focus to landing all fingers together. The phrase to repeat in your head is "block, not pluck."

Third, watching your fretting hand. You can't read the strumming hand's rhythm and the fretting hand's shape at the same time, and the rhythm is the harder thing to recover. Trust your fingers — they know where to go after a few hundred reps. Look at the strings instead, or close your eyes.

Why this transition matters

The G7 → Am change appears in a large share of beginner acoustic songs because both shapes belong to families that play comfortably together in common keys. Once this change is automatic, you'll find it everywhere — verses, choruses, and the resolution at the end of nearly every section. Investing one week here pays back across hundreds of songs in the FretMapper catalog.

If G7 still feels uncertain on its own, spend 10 minutes drilling it from the G7 chord page before working the transition. Same for Am — try the Am chord page first if it's still new. The transition assumes both shapes are reasonably reliable in isolation.

Songs that use both chords

Our current catalog focuses on traditional and public-domain material in keys that don't always require both G7 and Am together. Practice the change in isolation using the drill above, and apply it when you encounter the pair in your own songbook.

Reverse: Am → G7   All transitions